Command your water boiler

Here is how you can control your water boiler with Wattcube

Description

The Wattcubes can be used to add a control to a lighting or a water heater from an existing switch. The only constraint is the need to have phase and neutral in the switch.

Programming

  1. Once connected, pass the badge over the Wattcube Push
  2. Pass the badge over the Wattcube PowerDin (or Wattcube Open + 16A contactor)
  3. Pass again the badge over the Wattcube Push
  4. Connect to the Wattcube Web at http://wattcube-web/ or the IP address you have chosen before (192.168.1.10 by default)
  5. Connect to the Smartphone application and find the module corresponding to the one installed in the electrical counter. Rename it for example "switch-day-night". Click on the module and configure it as a "follower" so that the output of the Wattcube PowerDin reflects the input of the day-night contact (At night the water heater will be switched on)
  6. Rename the module corresponding to the Wattcube PowerDin connected to the water heater in the same way

Cabling schematic