Control an additional lighting from a two-ways switch
Here's how to add an additional lighting on a two-ways switch using a Wattcube Push and a Wattcube Light.

Description

The Wattcubes can be used to add a control to additional lighting from an existing switch. The only constraint is the need to have phase and neutral in the switch or lighting.

Programming

 

  • Once you have connected everything, pass the badge on the Wattcube Push
  • Pass the badge over the Wattcube Light
  • Pass again the badge over the Wattcube Push
  • If necessary, switch the Wattcube Push to "push button". Enter in the programming mode with the badge, press the switch 5 times, pass the badge again over the Wattcube push to exit programming mode. To return to the toggle switch mode, enter programming mode with the badge, press once and wait 10s. Pass the badge over the Wattcube Push to exit the programming mode.

 

Please note that the Wattcube Push module must be configured as a "follower" via the Wattcube Web, otherwise the status of the new lamp may be reversed.

Cabling schematic

Here is the schematic, we wish to control the lighting from this two-ways switch.

The first solution is to connect a neutral cable into the switch:

The other solution is to phase a phase into the lighting.