Wattcube Push2Din

 

The Wattcube Push2Din is designed to be connected to a switch, a push button or a 230V contact to be able to realize a CPL switch (on / off current switch).

This module has two inputs.

    • Compatible with pushbuttons or rocker switches

 

    • Ultra-fast and contactless programming using the Wattcube badge

 

    • Easy installation on 35mm DIN rail

 



    • Battery-free, mains powered



 



    • Range of communication over a cable length of more than 3 Km *



 



    • Can be used with a two-ways switch from 2 up to 16 switches



& nbsp;



    • Return status and acknowledgment, repeat order in case of failure



 

  • Communication by low-frequency line carrier (CPL) for remote control of electrical equipment.
  • No radiofrequency emissions and therefore are safe for health.
  • Connection where NEUTRAL + PHASE are available.
  • No grounding.
  • Communication and association between them using the Wattcube Badge .
  • Secure protocol communication to ensure that a command is sent / received.
  • 4 screw terminals of 4mm: phase, neutral and 2 inputs 230V
  • Compatible with all other modules in the Wattcube range.
  • Advanced switch functions (follower, inverter follower, always on, always off)
  • Extinction timeout functions, presence simulator and time schedule activated via Wattcube Web


CE marking according to EU Directives 2004/108 / EC-2006/95 / EC


  • New installation or renovation
  • Switch or pushbutton
  • Dry contact from output PLC (programmable logic controller)
  • Contact Report
  • Contact day / night electric counter

Leaflets, catalog or user manual available on your member area.

Min power 0.5VA
Internal protection 2A delayed fuse.
Mains voltage 230V +/- 10% - 50Hz
Carrier frequency 110KHz
Power Consumption Standby 450mW
Min delay 44ms
Ambient temperature - 20 to 45 ° C
Relative Humidity 0 to 99%
Dimension 90x17x60mm
Standards: