Your cart is empty! Go shopping »
The Wattcube PushDin is designed to be connected to a rocker switch, a push button or a 230V contact to be able to realize a CPL switch (on / off current switch).
This module has a single input.
- Compatible avec des boutons poussoirs ou interrupteurs à bascule
- Programmation ultra-rapide et sans contact à l’aide du badge Wattcube
- Installation facile sur rail DIN 35mm
- Sans pile, alimentation par le secteur
- Portée de communication sur une longueur de câble supérieure à 3 Km*
- Possibilité de faire des va-et-vient de 2 jusqu’à 16 interrupteurs
- Retour d’état et accusé de réception, répétition de l’ordre de commande en cas d’échec
- powerline communication (CPL) technology for remote control of electrical equipment.
- No radiofrequency emissions and therefore are safe for health.
- Connection where NEUTRAL + PHASE are available.
- No grounding.
- Communication and association between them using the Wattcube Badge . < / li>
- Secure protocol communication to ensure that a command is sent / received.
- 3 4mm screw terminals: phase, neutral and 230V input
- Compatible with all other modules in the Wattcube range.
- Advanced switch functions (follower, inverter follower, always on, always off)
- Extinction timeout functions, presence simulator and time schedule activated via Wattcube Web
CE marking according to EU Directives 2004/108 / EC-2006/95 / EC
| Min power | 0.5VA |
| Internal protection | 2A delayed fuse. |
| Mains voltage | 230V +/- 10% – 50Hz |
| Carrier frequency | 110KHz |
| Sleep consumption | 450mW |
| Min delay | 44ms |
| Ambient temperature | – 20 to 45 ° C |
| Relative Humidity | 0 to 99% |
| Dimension | 90x17x60mm |
| Standards: |
- New installation or renovation
- Switch or pushbutton
- Dry contact output from PLC (programmable logic controller)
- Contact Report
- Contact day / night electric counter
Leaflets, catalog, user manual available on your member area.